10 hole Driller   

The ATM 10 Hole Driller was designed to have all the weight over the drill head and equipped with 12mm adjustable chucks, which will accommodate any type of parallel shank drill up to 12mm diameter with a length not exceeding 200mm. larger drills can be used with reduced shank. This machine has 25.5mm shafts with two 25.4mm bearings on each shaft and driven by only one chain.   

- Fitted with a 1.5hp 240 or 415 volt electric motor
- Variable Longitudinal drilling pitch, between 50mm to 200mm. with a ratchet drive system
- Nylon slides system for the drill head and side slides
- Lubrication for chain only all bearings are sealed for life
- Cord carrier bar for electrical cable
- On off switch placed on handle
- The ATM drilling machine is a low maintenance machine